02-Hand Held Punches A range of low cost marking punches for use by hand and hammer. Hand held Punches are available in a wide range of sizes and styles. Used for single character marking. Features: Made up of special alloy steel with precise heat treatment, gives a hardness of 58-61 Rockwell C at the character end and 35-40 Rockwell C at the striking end. Can be used without fear of breakage or premature character wear. Nickel plated Character sizes from 1.6mm to 20.0mm in sets of figures 0 - 8, letters A - Z or combination sets. Packed in strong wooden boxes with separate compartments for each stamp, to allow rapid selection. Suitable for all engineering and Industrial applications 2.1 Standard Standard Punches to mark sharp faced single characters. 2.3 Lowstress Rounded characters for low stress marking, especially for use in the Aircraft, Nuclear and Oil industries. 2.2 Reverse Used for marking single sharp faced characters to give a reverse impression (in moulds for example). 2.4 Inspection Stamp Non standard punches including inspection stamps, and non-standard sizes and inscriptions for our standard range.     Address: 206, Alpine Industrial Estate, Marol Millitary Road, Marol, Andheri (E), Mumbai-400 059. INDIA Telphone No: (00) (91) 22 2920 6910, (00) (91) 6704 9747, Telefax: (00) (91) 22 2920 6754 Mb.:+91 92243 24378 Email: sales@benchmark63.com 1111 1111